|
Post by thomasbk on Sept 23, 2018 15:22:09 GMT
Hello
I have some airports with SODE jetways, and many of my [exits] in planes do not match the jetways. I want to make new [exits] but how do i do it? is there a tool for it?
|
|
|
Post by aerofoto - HJG Admin on Sept 24, 2018 15:28:09 GMT
If it´s JETWAY/AIR BRIDGE data your referring to (for FSX use) .... then I can only refer you to the following HJG forum thread within which the required co-ordinates for some of our aircaft is stated. Try this .... tonymadgehjg.proboards.com/thread/5565/jetway-mods-hjg-aircraft-fsxSo far as I´m aware .... it´s a simple case of copying & pasting the EXIT data provided to the "EXIT" section of each AIRCRAFT.CFG file .... for the appropriate aircraft type/s of course. Some of our aircraft will already feature it .... others will/may not. Mark C BOG/CO
|
|
|
Post by tgibson on Oct 14, 2018 18:40:11 GMT
We've used trial and error in the past to find the correct numbers. Copy over a working exits section from a similar plane and paste it in (if there is no exits section present). Then modify the numbers until the jetway moves to the door correctly.
As I remember the numbers are:
1. Open/close rate in percent per second/100 2. Forward/aft from aircraft datum point (0,0,0 point) 3. Left/right 4. Up/down 5. Type of exit: 0 = main, 1 = cargo 2 = emergency
|
|