|
Post by egajet on Nov 26, 2007 19:24:41 GMT
First of all many thanks for this fantastic work!! Very, very nice!
I do have a problem with the radio tuning because I cannot adjust neither VOR´s nor NDB´s (COMM´s are OK).
Actually there is a specific FAQ for this issue but that doesnot apply here because my installation is according to the instructions. Also the avionic busses are ON.
Can someone shade some light on this issue? What can I be doing wrong? (I know I am...).
Thanks
Edmundo
|
|
|
Post by matthiasl on Nov 26, 2007 21:19:18 GMT
Hi Edmundo,
There could be two reasos for this:
Please check if you have switched on the Avionic Master switches A and B in the overhead panel (upper left side). A second reason could be that you did not have installed the gauges directly into the FS gauges folder. This is important, because otherwise you could not see and adjust the radios.
Best Regards Matthias
|
|
|
Post by egajet on Nov 26, 2007 21:55:37 GMT
Hi Mathias,
Again, many thanks for this beautiful panel.
Avionic master switches are on. Because I prefer to install gauges in the panel folder, I had first all the gauges , ini and cfg files in the BAe146 panel. I moved thm all them later to the Fs9 gauges folder (after quiting of couse from FS9). In both situations the dials didn´t work. But I will try again. May be a reboot can clear the situation!
Best regards
Edmundo
|
|
|
Post by aerofoto - HJG Admin on Nov 26, 2007 22:09:30 GMT
As Mathias has pointed out in his installation instructions outlined within the PDF manual which downloads with the BAe 146 panel .... those 7 gauges components contained within the downloaded Panel Gauges ZIP file "MUST" all be installed inside the FS9 "GAUGES" folder and not the aircraft panel folder as is practical for some other FS aircraft.
Please don't put these gauges inside your aircraft Panel folder or the panel will likely not function.
"GGOD IDEA" !
After making any change to FS it's always a good idea to shutdown then restart .... so FS can be made aware thar a change has taken place.
Otherwise FS will always remember a previous condition/configuration.
Also .... when making any changes to anything make sure FS has first been shutdown/exited properly before attempting to make any such changes.
Mark C BOG/CO
|
|