|
Post by pastormartin on Oct 21, 2010 16:25:02 GMT
First of all, what a spectacular AC! I am flying it in two different VA's and it works well in both settings! Now the question! The climb rate is very slow.... I tried it with the AT and AP set at 250 and vs at 1500 but it would only maintain it up to about 8000ft and then beginning to slow. I've tried it without the AT set and it's a bit better, but I end up at 700fpm above 15K. I'm not using the Matthias panel, still learning it, but I'm using another panel instead. What do I need to do to increase the VS? JC THanks for a great AIRCRAFT!
|
|
|
Post by pastormartin on Oct 21, 2010 16:45:44 GMT
Sorry about not adding this to the above, but the AC I am using is the Jon Murchison Bae146-300 for FS9 and I downloaded it from the Tradewind Caribbean website. Should I download the base pack from the HJG website and reinstall the textures? JC
|
|
|
Post by garryrussell on Oct 21, 2010 18:32:39 GMT
Hi JC
I would be better if you start again with the packages from here.
There is no point in people here trying to answer to a package that may be different in some small but vital way.
I suggest you download and then check to see if the problem is still present and if it is, we can take it from there.
ATB
Garry
|
|
|
Post by aerofoto - HJG Admin on Oct 21, 2010 19:21:07 GMT
Garry is "QUITE RIGHT" ! If you downloaded your BAe 146-300/RJ100 from anywhere else then the FDE is likely different from that which we offer here. Jon's model which we offer "HERE" is probably the same as that available anywhere else .... it's certainly the most recent/last version released by him/ARNZ. Our MIke MONCE did a lot of FDE work on this aircraft .... to improve various aspects of its performance, so, the FDE we offer "HERE" is specific to this website .... and will likely result in various improvements over what you've been using before now. I do recommend the ML BAe 146 panel .... because despite its complexity you won't find a better version available for FS. AND .... on the sounds page of this website you'll also find our AEROMUSICA soundpack for the BAe 146/ARJ series .... which is pretty accurate too. In fact .... there a lot of data "HERE", at HJG, to help improve/enhance your BAe 146/ARJ experience. I'll certainly be curious to know how our data compares with that which you've apparently been using before now. Mark C AKL/NZ
|
|
|
Post by pastormartin on Oct 22, 2010 10:19:17 GMT
Thanks for the replies. They make perfectly good sense. I'll download the base pack and begin there. BTW, I have downloaded the sound pack and it's great, and ML panel. Just haven't had time to familiarize with the panel yet and I was anxious to fly! Thanks again for a great AC JC
|
|
|
Post by aerofoto - HJG Admin on Oct 22, 2010 10:59:20 GMT
"THANKS" be to Jon MURCHISON for the model .... first and foremost. Then to Mathas LEIBRECHT for the panel. And then our own HJG tyeam for the FDE revisions .... he means, I'm sure, since the BAe 146-300/RJ100 represents an aircraft we imortd to HJG ! Mark C AKL/NZ
|
|
|
Post by pastormartin on Oct 22, 2010 12:09:45 GMT
I downloaded the base pack here, and then installed the ML panel and a couple of textures. The AC as designed by JM and the panel by ML are great, and the FDE by the HJG staff is perfection. Thanks to all of you for a great AC in the FS community hangar.
JC
|
|
|
Post by aerofoto - HJG Admin on Oct 22, 2010 19:52:13 GMT
Glad to know you've found contentment .... in our editing of this great FS aircraft.
I trust then that your ealier iperformance ssues must have been related sole around that other non-HJG FDE !
Mark C AKL/NZ
|
|
|
Post by pastormartin on Oct 23, 2010 19:14:56 GMT
Mark, That would certainly seem to be the case, that the other FDE, et al, caused the problem. The AC is a truly wonderful ac to fly. Thanks for all of the help. BTW, our daughter-in-law lives in Cali, Colombia. JC
|
|
|
Post by garryrussell on Oct 23, 2010 21:10:13 GMT
Glad you're sorted.
Anything downloaded here is fully supported and expert help is always readily to hand.
ATB
Garry
|
|