|
|
Post by varun747vabb on Jun 25, 2017 9:54:51 GMT
Dear respected Members Despite following all known literature of why HJG aircraft do not appear in the FS9 aircraft selection menu, my ALL HJG Aircraft are still not appearing in the FS9 Aircraft selection menu I have installed both sound and panel files,i have gone thru the CFG a thousand times, gone thru the installation procedure many times but doesnt seem to work. If anyone could point out my mistake or help me out it will be much appreciated  |
|
|
|
Post by walterleo on Jun 25, 2017 14:19:08 GMT
Hi Varun:
Make a screenshot of your aircraft folder under FS and post it here. In general and in your case as all HJG aircraft dont apear something in your installation procedure is amiss. AND dont forget to enable the "write" privilege for the entire FS folder.
Kind regards
Walter
|
|
|
|
Post by aerofoto - HJG Admin on Jun 25, 2017 20:39:57 GMT
If you've tried to edit an image into your your first posting, then, that's not appearing either. Need to know a precisely which ARJ/BAe aircraft type version and texture/s (airline livery, date, and registration you're trying to install) in order to able to proceed with this sensibly and with relative ease. Allow me to hint though .... 99.999 % of all FS "no shows" are the result of installation misconfigurations/errors (interpetations of these directions at least) .... usually a case of something not being edited correctly or a valid folder for the simulation still being contained within a containing/folder from the original ZIP file. Get back to us with more information please .... and we'll be glad try'n sort you out  Mark C AKL/NZ |
|
|
|
Post by varun747vabb on Jun 26, 2017 7:39:09 GMT
Here you go guys i fixed the image
but i tried installing it properly but it still doesn't work.
Thank you for help
|
|
|
|
Post by walterleo on Jun 26, 2017 7:49:59 GMT
Hi Varun:
The solution is easy:
For some for me unknown reason FS 9 does not accept in the aircraft.cfg flightsim=00 or 01 ....
Therefore change
[fltsim.00] to [fltsim.0]
and [fltsim.01] to [fltsim.1].
and so on!
It is easy to tumble over that, I did that also once in a while.
Good luck!
Walter
|
|
|
|
Post by aerofoto - HJG Admin on Jun 26, 2017 8:54:03 GMT
Now we can seen the ADD TO AIRCRAFT portion of his imaged CFG data .... I concurr with Walter  Those [FLTSIM.XX] enries for for each texture should read as follows ..... [FLTSIM.0] [FLTSIM.1] .... with any further texture additions for this BAe 146-300 base pack then appearing as follows .... [FLTSIM.2] [FLTSIM.3] Just a simpe editing misinterpretation. Always start the very first entry at "0" (zero) .... and with every subsequent [FLTSIM.XX] entry then reading consecutively and in numerical order. That should resolve your problem Mark C AKL/NZ |
|
