|
Post by Dan K. Hansen on Dec 23, 2008 22:09:51 GMT
And you are of course sure that you got the model from here, not anywhere else?
|
|
|
Post by bober on Dec 24, 2008 16:11:06 GMT
And you are of course sure that you got the model from here, not anywhere else? Of course there is model HJG (HJG_Boeing_E3-C_v6.zip) From your webpage I use Saitek Pro Flight Yoke and Logitech Extreme3D Pro joystick as rudder.Calibration I have made one more time,all right.I have made too "new" fsx.cfg. I tested too E3-C with boeing747-400.air.It has given nothing. Still continuously to right. Other aircrafts behave well.(small, fighters, default 738, 744, Bae 146 etc.) Wojtek
|
|
|
Post by aerofoto - HJG Admin on Dec 24, 2008 23:00:51 GMT
"BOBER" .... this must be caused by something on your own set-up .... because I simply can't replicate your problem/experience with either the model, FDE, or recommended panel concerned either.
Mark C AKL/NZ
|
|
|
Post by bober on Dec 26, 2008 0:04:44 GMT
"BOBER" .... this must be caused by something on your own set-up .... because I simply can't replicate your problem/experience with either the model, FDE, or recommended panel concerned either. Mark C AKL/NZ Probably I have solved problem.I must else check, but certainly there was my stupidity Fuel was distributed not evenly, Main Tank 3 had always 100 % Capacity. I can say about I "old but silly" I did read not exactly Fuel System Tutorial but I know english slightly. Sorry and best regards, Wojtek EPKK Poland
|
|
|
Post by aerofoto - HJG Admin on Dec 26, 2008 5:21:02 GMT
"YES" .... a fuel imbalance (or otherwise improperly loaded/configured fuel quantity) is one of a number of factors which can cause these aircraft to run off the RWY during T/O.
I'm glad to know you're making progress there "BOBER".
Mark C AKL/NZ
|
|
|
Post by untensil on Jan 28, 2010 21:56:05 GMT
i have had problems too, my 707-420 worked fine with a default 747 panel in FSX but when i installed the 707-420 panel the engines would not start. Also i do not think this panel has a engineers panel or a way of doing an engine start manually.
|
|
|
Post by aerofoto - HJG Admin on Jan 28, 2010 23:18:58 GMT
A very specific manual engine startup tutorial, for these panels, is included within my B707 PANEL INSTALLATION & HANDLING NOTES .... on the ABOUT HJG AIRCRAFT forum page. Miss a single step in this procedure and you willl not be able to start your engines. These procedures, as prescribed by me, work perfectly.
YES IT DOES !
In fact "ALL" of the HJG B707 panel series, by George CARTY, feature an F/E panel .... and .... manual engines startups, for each individual engine, are perfectly practiceable. Each of these panels is also FS2004 and FSX compatible.
Only the B707 panel by Marco BALZAROTTI & Michael VERLIN does not feature an F/E panel .... but still .... manual and individual engine startups are fully practiceable with this panel too. PLEASE NOTE THOUGH .... this particular/single panel is FS2002 & FS2004 compatible only.
Mark C AKL/NZ
|
|