|
Post by bobdawkins on Mar 26, 2009 14:13:23 GMT
Something worth checking if your panel doesn't show up, even after following all instructions to the letter, I couldn't work out why my panels were not working, every thing was in the right place, then after a couple of hours, found out what it was, copying into my panel folder cfg, I didn't realize that I had missed out one of the brackets, hence no panel showing, (highlighted in red,) so each aircraft that had this panel, there was no panel showing. [fltsim] alias=fsfsconv\panel.b727 so the moral of this story is, Don't forget your brackets
|
|
|
Post by aerofoto - HJG Admin on Mar 26, 2009 19:32:29 GMT
Is there a "typo" (missing bracket) in our B727 panel installation instructions "BOBBO" ? Mark C AKL/NZ
|
|
|
Post by bobdawkins on Mar 26, 2009 21:07:43 GMT
No most definitely not, it was when I was installing--- [fltsim] alias=fsfsconv\panel.b727 that it turned into this fltsim] alias=fsfsconv\panel.b727 my fault entirely whilst copying and pasting, but it just goes to show that something as this, "typo" (missing bracket), can complicate things, every thing is running great now, I've discovered my own error, so I can't sue HJG for non panel flying of aircraft, I'll have to think of something else now, ;D ;D Now where did I put that missing bracket !!!!
|
|
|
Post by aerofoto - HJG Admin on Mar 26, 2009 21:19:47 GMT
OH .... you mean you stuffed it up all on your own little lonsome ! ;D Folks .... and this's really intended for those less experienced FS enthusiasts among us .... What "BOBBO" stresses here (the need to be cautious when editing .... checking everything as it's edited .... and the fact such small errors can have such dire consequences) is all very significant. It's minor CFG editing errors such as these that account for more than the majority of "no shows" within FS. Thanks for sharing your experience "BOBBO" ! Mark C AKL/NZ
|
|
|
Post by bobdawkins on Mar 26, 2009 22:39:47 GMT
Alright don't have to rub it in, ;D but it just goes to show, have been configuring cfg for quite a few years now, and still make a small error, what a plonker, (ignore signature) ;D ;D
|
|