|
Post by fbrosius on Aug 15, 2010 18:51:58 GMT
…not deploy or retract. If I hold the F-8 key down the flaps will extend. As soon as I let the key go they retract. I have no problem of this sort with the DC-8. The landing gear will also not retract and again; no such problem with the DC-8. I have FS9 and have removed the FSX Aircraft files. Anyone have any ideas? Thank You.
|
|
|
Post by aerofoto - HJG Admin on Aug 15, 2010 21:07:19 GMT
Yes they do work .... but .... to make them work it is imperative that folk take time to revise/familiarise themselves with the online manual .... "DC9 PANEL INSTALLATION & HANDLING NOTES". Both FLAPS and GEAR functions are well covered within section 1.2 of this manaul which is entitled .... "SECONDARY ENGINE INSTRUMENTS" Essentially .... the FLAPS and GEAR cannot/will not work until the 2 center Hydraulics switches, located on this secondary engine intruments panel, are both set to the "HI" position. Please consult the said manual for full advice regarding this It is recommended that folk new to these HILMERBY/CARTY DC9 panels take the time necessary to "READ" the online/forum manual "THOROUGHLY". Most of everything one needs to know regarding these panels .... and more .... is covered there and is intended to improve folks understanding and enjoyment of everything associated these panels and aircraft. Mark C BOG/CO
|
|
|
Post by fbrosius on Aug 16, 2010 2:01:36 GMT
I did not know that that was the case on this panel… Thank You. ;D
|
|