|
|
Post by grayrider on Sept 20, 2010 21:18:48 GMT
Hello again. I thought I whould start a new thread on my progression. Any way I put together my first package on my own I installed the RC-135 JT3D package.There is one paint for each of the four models.The models are the E/S/W and U model. I installed the package,and did fly the "E" and the "S".So the package went in fine. There is a paint config problem with the "W" model from the error I get etc.I will provide the screenshot,plus two others. So for know the "W" and "U" model won't show up,based on the error. I put the textures in without an issue,the way I downloaded them etc. The error deals with the titles of some sort?.The "U" model should have shown up I would think.    I feel I did a pretty good job with this package,because I think one of the paint config's is wrong from the download section etc. Anyway.If Dan or some one look at the paint config's,based on the error. THX GrayRider |
|
|
|
Post by Dan K. Hansen on Sept 20, 2010 23:28:34 GMT
fltsim.1 and fltsim.2 has the same title hence the error.
|
|
|
|
Post by Dan K. Hansen on Sept 20, 2010 23:29:17 GMT
it actually says which title that is the culprit in the error message.
|
|
|
|
Post by grayrider on Sept 20, 2010 23:36:47 GMT
How do I correct both of them,or what do I have to change.the error seems to affect more than just the title in bot config's.Unless someone could correct the ones in the download section,so I can replace the config's,with the one's I have etc.
GrayRider
|
|
|
|
Post by grayrider on Sept 21, 2010 0:34:25 GMT
I did get the "W" paint to show up.I am not getting the error any longer.I did correct the title.The "U" paint still has an issue in the texture config.and still not showing up.
I'm looking at the "U"paint config now,but I don't see whats wrong with it?.
GrayRider
|
|
|
|
Post by Dan K. Hansen on Sept 21, 2010 7:04:38 GMT
the texture section in fltsim.1 points to "....2000...." and the actual folder name is "....2006..."
Please be very carefull when naming, and take special attention ofn the model, sim, panel and texture section. In the aircraft.cfg file the text after the "=" must match then name after the "." in the respective folders
e.g.
Text in aircraft.cfg:
texture=mypaint
folder name:
Texture.mypaint
I would suggest that you took a little time getting familiar with the way things are, instead of just hasting into "why don't it work" .... it will be more fulfilling when it actually "snaps" :-)
And do take some time flying, instead of using all your time installing :-)
|
|
