|
|
Post by northeastern292 on May 24, 2013 17:20:19 GMT
I downloaded yesterday the MD-80/87/90 series and I've run into two bugs, one beyond anyone's control
1) The Concorde visor commands do not extend/retract the front airstair.
2) The one that concerns me: The jetway points do not work for the MD-80's (except for the MD-87) and the MD-90. I hit CTRL+J as I normally would and the jetways do not move.
I'm stumped because everything looks correct. Anyone have insight?
|
|
|
|
Post by Dan K. Hansen on May 29, 2013 1:21:54 GMT
Hm... I'll check the aircraft.cfg once again ... You did get them from our site, right?
ad. 1 The Concord nose visor has changed dramatically between FS9 and FSX, and are likely not to work in FSX because of several new commands.... not much to do about it apart from either re-compile the FS9 model with an other command, or make a completely new genuine FSX model... which I can't see come
|
|
|
|
Post by aerofoto - HJG Admin on May 29, 2013 12:16:51 GMT
Remember .... the CONCORDE visor commands which facilitate the MD80/90 forward airstairs animations are based on FS2000 commands/assignments (quite common in later FS versions) .... and which work fine in both FS2002 and FS2004 .... and in FSX too so far as I´m aware .... BUT .... these do need to be "manually assigned/set up" within the FS OPTIONS/ASSIGNMENTS.
Provided this´s done, correctly, then one should experience no difficulties .... at all.
Mark C
BOG7COL
|
|
|
|
Post by Dan K. Hansen on May 29, 2013 14:22:38 GMT
Like I said Mark ...especially the Concorde commands have overgone a dramatical change from FS9 to FSX, and it is certainly not given that the old FS9 commend have any FSX equivalent...
Speaking of Jetways, you may check the very first post in this where Bob have line up a series of Exit coordinates, also for the MD's .... that should make your jetways work
|
|
|
|
Post by northeastern292 on May 31, 2013 22:00:04 GMT
Hm... I'll check the aircraft.cfg once again ... You did get them from our site, right? ad. 1 The Concord nose visor has changed dramatically between FS9 and FSX, and are likely not to work in FSX because of several new commands.... not much to do about it apart from either re-compile the FS9 model with an other command, or make a completely new genuine FSX model... which I can't see come Yeap, got them from here. The Concorde visor command issue is a loss, but at least I got the jetways working. Bob's commands are right on the spot, glad to say, so that's why I haven't replied. Needless to say, the HJG MD-80 series is I think my favorite model of the MD-80 I've encountered so far in FS. Like I said Mark ...especially the Concorde commands have overgone a dramatical change from FS9 to FSX, and it is certainly not given that the old FS9 commend have any FSX equivalent... Speaking of Jetways, you may check the very first post in this where Bob have line up a series of Exit coordinates, also for the MD's .... that should make your jetways work I love FSX, and it's included eye candy, but I think MS could have done a little bit better in regards to backwards compatibility. |
|
